The Sliding Shaft Of Mini Cement Plant from 's blog
The sliding shaft of the mini cement plant is worn for a long time and reaches a certain thickness, the spherical body of the mini cement plant and the tile lining are difficult to combine, and scratches will occur. In general, this kind of situation is mostly because the temperature of the clinker of the hollow shaft is too high, and the temperature of the outer surface of the hollow shaft is also high, which causes the lubricating oil to be too diluted, lose its viscosity, and it is difficult to form a good oil film, causing the bushing and journal.
Friction generates heat and heats up rapidly, causing the surface of the tile lining to be melted and scratched. If there is no spare spherical tile, it can only be stopped for inspection, and the tile surface can be repaired before continuing to use. The smoothness of the scratched surface can be restored by filing, cutting, grinding, etc., but the undamaged part needs to scrape out a micro oil groove, repair the tile mouth, and empty the material and grinding medium in the mini cement plant.
Manual methods are used. , Rotate the cylinder for no-load grinding, and when it reaches a certain level, carry out a no-load test operation with the transmission part, and then load the material and grinding medium into the mini cement plant for load operation, so that the mini cement plant can resume normal operation.
Friction generates heat and heats up rapidly, causing the surface of the tile lining to be melted and scratched. If there is no spare spherical tile, it can only be stopped for inspection, and the tile surface can be repaired before continuing to use. The smoothness of the scratched surface can be restored by filing, cutting, grinding, etc., but the undamaged part needs to scrape out a micro oil groove, repair the tile mouth, and empty the material and grinding medium in the mini cement plant.
Manual methods are used. , Rotate the cylinder for no-load grinding, and when it reaches a certain level, carry out a no-load test operation with the transmission part, and then load the material and grinding medium into the mini cement plant for load operation, so that the mini cement plant can resume normal operation.
Post
Rate
Archives
- All
- January 2023
- November 2022
- September 2022
- August 2022
- July 2022
- May 2022
- October 2021
- September 2021
- August 2021
- July 2021
- June 2021
- May 2021
- April 2021
- March 2021
- January 2021
- December 2020
- November 2020
- October 2020
- September 2020
- August 2020
- July 2020
- June 2020
- May 2020
- April 2020
- March 2020
- January 2020
- December 2019
- November 2019
- October 2019
- September 2019
- August 2019
- July 2019
- June 2019
- May 2019
- April 2019
- March 2019
- February 2019
- January 2019
- December 2018
- November 2018
- October 2018
- September 2018
- July 2018
- June 2018
- May 2018
- April 2018
The Wall