In the process of using raymond grinding, failure is the two major factors that trouble normal production. The occurrence of failure will stop production and cause a great impact on normal production. The occurrence of faults leads to the shutdown inspection of the machine and the direct increase in maintenance costs. Therefore, we must pay attention to the use of raymond grinding equipment during production to reduce fault problems.

For users, there are two big problems in reducing failures. The appearance of raymond grinding failure is like two nightmares, how to avoid it? Undoubtedly, reasonable maintenance will reduce the failure rate, so we need reasonable maintenance, good maintenance, and good work.

Then, every lubricating point should be filled with lubricating oil according to the requirements of raymond grinding every day. Only in this way can each bearing be lubricated adequately and the bearing life can be extended. When starting, it is necessary to restrain the friction torque between the axle and the bearing, and also restrain the moment of inertia of the rotating cylinder and the material. Therefore, a motor with a large starting torque should be selected. Clean the residual material in the fuselage, turn off the dust collector, turn off the main power supply after the comparison, and complete the production operation. You need to grease the main engine and reducer bearing seat every month to ensure the lubricity of the bearing.

If there is a power failure, the heat source should be turned off, the machine naturally cools down, and the equipment is cleaned. After each work, the residual fluid in the barrel raymond mill equipment should be cleaned up in time to increase the temperature rise rate. Check the main unit, reducer, dust collector, fan and other devices of the milling ratio to lubricate all bearings and friction surfaces, which have a very important effect on the use effect. When we are producing, we must pay great attention to these production phenomena. During production, we must pay attention to vibration, which will have a great impact on the quality of production. We should not take it lightly, but should pay great attention to it, so as not to affect the effectiveness and efficiency of production.

In production, just sticking to the above points every day can greatly reduce the frequency of raymond grinding failures and achieve safe and stable production. This is an important measure.