In order to reduce the failure of the marble grinding machine in the production process, the newly purchased equipment will be tested after the installation, so that the equipment itself and the installation process may be faulty. This is the purpose of the test operation. Let me introduce what the correct operation of the test run is.

The first is the no-load operation. When the material is not added, run the marble grinding machine machine. Then observe whether the screws and other parts are loose, the wire connection is normal, and the wire needs to be protected from being pressed. Otherwise It will cause line problems. It is also necessary to pay attention to the presence of noise and other abnormalities. If not, the no-load operation takes 2 to 4 hours, so that the possible faults can be fully observed. During the operation, pay attention to whether the bearings of the marble grinding machine are Will be hot, etc., these will be carried out without problems after the load;

The second is the inspection of the marble grinding machine on-load operation. It is to add materials to the equipment and then make it run. In this process, besides paying attention to whether the screws, rotors, etc. are loose, pay attention to the order of starting the machine to prevent improper start-up. The damage caused by the test machine is usually 8 to 12 hours. The problem to be paid during the operation is whether the bearing and other components have faults. The sequence of the shutdown after the end of the operation cannot be wrong.